Panasonic EASA-PHONE KX-T123210 Installation Manual page 88

:..:....................unti I the desired CO number (01 through 12) appears
...................................
C= dial the trunk group number (1 through 8)
q
: trunk group number 1
q
: trunk group number 8
lefault
CO 01 is assigned to Trunk group 1.
CO 07 is assigned to Trunk group 7
CO 08, 09, 10, 11 and 12 is assigned to Trunk group 8.
-{ AB=
q
: to assign the same on all 12 CO' s 1
.
Description
2.
When outside lines are grouped, an idle line
within the trunk group is automatically found and
connected when an outside call is placed.
A maximum 8 groups can be assigned.
For example, if subscribing with multiple
telephone service companies, the CO lines can be
grouped as shown below by each company.
3.
4.
5.
Trunk Group 1
Trunk Group 2
Trunk Group 3
Service Company A
Service Company B
Service Company C
Refer to " Outward Dialing (Individual Trunk Group
Access)" on page 4-3 and " Flexible CO Button (To
Assign into Trunk Group Access Number)" on page
4-53.
Programming
1. Dial (44).
" Trunk Group" will be displayed.
@II :
on CO 01
1 111121 :onCO12
6.
Press the NEXT button.
" CO NO ? +" will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
" CO 01: TRK GRP-1" will be displayed and " 1"
will blink.
Dial the trunk group number (1 through 8).
Press the MEMORY button.
The LCD will stop blinking.
l
To advance to the next CO number,
press the NEXT button.
o To return to the previous CO number,
press the PREV button.
o To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6, to program the trunk group
number on the other CO lines.
8. To return to the initial program mode, press the
END button.
Programming Table
See page 7-10.
,
3-46