Panasonic EASA-PHONE KX-T123210 Installation Manual page 207

To set
: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To confirm
Dial any extension (100 through 199) and listen for that extension to ring.
Description
DTMF (Dual Tone Multi Frequency) Receiver
enables tone telephones to dial within the system.
To check the DTMF Receivers, activate the DTMF
Receivers one at a time and confirm if the receiver
can receive tone signals.
at Extension Connected to Jack
Number 1.
To Remove DTMF Receive 2 and 3:
1. Set-the System Program Switch on the
KX-I123210 to the "PITS" position.
2. Dial (30) to enter the DTMF mode.
"DTM F Receiver" will be displayed.
3. Press the NEXT button.
"DTMF-R NO?+" will be displayed.
4. Press the NEXT button, twice, or dial (2).
5. Press the SELECT button to change to
"Disable".
6. Press the MEMORY button.
7. Press the NEXT button, or press the SELECT
button and then dial (3).
8. Press the SELECT button to change to
"Disable".
9. Press the MEMORY button.
. . . . . . . until the desired DTMF receiver appears
: receiver 2
: receiver 3
10. Press the END button to return to the initial
program mode.
11. Set the System Program Switch to the
"SET" position.
Confirmation of DTMF Receiver 1:
1. Set the DIALING MODE (located on the rear of
KX-T123230) switch to the TONE position.
2. Set the POWER FAILURE (located on the rear
of KX-T123230) switch to the ON position.
3. Dial the extension number (100 through 199).
4. If DTM F Receiver is bad, do the following
procedure for removing the DTMF Receiver
after the next step on this section.
5. Set the POWER FAILURE Switch to the OFF
position.
l
To check DTMF Receiver 2, remove DTMF
good by the procedures of "To Remove DTMF
Receiver 1 and 3" and "Confirmation of DTMF
Receiver 2".
l
To check DTMF Receiver 3, remove DTMF
Receiver 1 and confirm that DTMF Receiver 3 is
good by the procedures of "To Remove DTMF
Receiver 1 and 2" and "Confirmation of DTMF
Receiver 3".