Fujitsu Eternus2000 Manual page 99

2-2 Connect the SAS (OUT) port at expander 1 (EXP#1) of the Drive Enclosure 1, to the
The following figure shows the miniSAS connection figure between Drive Enclosures.
Drive
Enclosure 2
Drive
Enclosure 1
Controller
Enclosure
Figure 4.2
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Connect the connector to be connected to the SAS (IN) port, to the SAS (IN) port of the
expander 0 (EXP#0) for the Drive Enclosure 2.
Drive Enclosure 2
SAS (IN) port at expander 1 (EXP#1) of the Drive Enclosure 2.
Connect the miniSAS cable in the same way as
SAS (IN) SAS (OUT)
port port
MiniSAS cable connection
(When two or more Drive Enclosures are added)
Copyright 2009 FUJITSU LIMITED
Step 2-1.
EXP#0
EXP#0 EXP#1
CM#0
Chapter 4 Setup
SAS (IN) SAS (OUT)
port port
EXP#1
CM#1
4
75