Fujitsu Eternus2000 Manual page 88

4.2 Cable Connection
1
2
3
64
Connect the LAN cable to the ETERNUS2000.
Connect the LAN cable connectors to the MNT ports of the controller 0 (CM#0) and controller 1
(CM#1) for the ETERNUS2000.
CAUTION
• When connecting the LAN cables, position them so that they
Connect the LAN cables to the networking equipment.
Connect the other end of the LAN cable to the networking equipment, such as hub or router. For
more details, refer to the manuals of the network equipment that is to be connected to.
If the RMT ports are to be used, connect the LAN cables to RMT ports.
3-1 Connect the connector of the LAN cable to the RMT port of the controller 0 (CM#0)
and controller 1 (CM#1).
3-2 Connect the other end of the LAN cable to the networking equipment, such as hub or
router.
For more details, refer to the manuals of the network equipment that is to be connected to.
Do
will not obstruct replacement of the power supply unit or con-
trollers by the maintenance engineer.
ETERNUS2000 disk storage system User Guide
Copyright 2009 FUJITSU LIMITED
P3AM-2512-03EN