Fujitsu Eternus2000 Manual page 87

CAUTION
LAN cable connection procedure
The following explains how to connect the LAN cable.
This example is for the Fibre Channel type. For the iSCSI type port locations, refer to
type controller (rear view closeup)" (page
type controller (rear view closeup)" (page
Point
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Do
• Before starting, make sure to attach a wrist strap or touch the metal
frame of the device to eliminate static electricity. Failure to discharge
static electricity may cause device failure.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause damage.
Do Not
• Do not bend the cable too much or bind it up. Doing so may cause
device damage or failure.
90
Do not bend square
28). For the SAS type port locations, refer to
29).
When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the con-
nector.
Copyright 2009 FUJITSU LIMITED
Do not bind up
Chapter 4 Setup
4
"Figure 2.6 iSCSI
"Figure 2.7 SAS
63