4.2 Cable Connection
MiniSAS cable connection procedure
The following explains how to connect the miniSAS cable.
This example is for the Fibre Channel type. For the iSCSI type SAS (OUT and IN) port locations, refer to
"Figure 2.6 iSCSI type controller (rear view closeup)" (page
port locations, refer to
72
"Figure 2.7 SAS type controller (rear view closeup)" (page
• When connecting miniSAS cables, always check the symbols on the
Point
connector and port are matching.
SAS (OUT): Attach the connector with the
the
SAS (OUT)
Controller
Enclosure
Drive Enclosure
SAS (IN): Attach the connector with the
the
SAS (IN) port
• When connecting miniSAS cables, check the connector orientation
and then firmly push it all the way in.
When disconnecting miniSAS cables, use the pull-tab to extract the
connector.
miniSAS cable
Copyright 2009 FUJITSU LIMITED
28). For the SAS type SAS (OUT and IN)
symbol.
Plug connecting to SAS (OUT) port
symbol.
Plug connecting to SAS (IN) port
ETERNUS2000 disk storage system User Guide
29).
symbol to the port with
symbol to the port with
tab
P3AM-2512-03EN