Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
25.9
Disable / re-enable routing equipment (H2/B9) _________ 102
25.10
26
Set calendar and clock (H3) _________________ 104
27
Present system status (H4) __________________ 105
27.1
Disablement (H4/U1) _____________________________ 105
27.2
Disablement by time channel (H4/U2) ________________ 106
27.3
Open doors (H4/U3) ______________________________ 107
27.4
Sensor values (H4/U4) ____________________________ 108
27.4.1
Reset of a week average sensor value _____________ 110
27.5
Sensors activating SERVICE signal (H4/U5) ___________ 111
27.6
Event log (H4/U6) ________________________________ 112
27.7
Show information (H4/U7) _________________________ 112
28
Service (H5) ______________________________ 115
28.1
28.2
Calibration of supervised outputs (H5/A1) _____________ 117
28.3
Sensitive fault detection mode (H5/A2) _______________ 118
28.4
Service mode for COM-loop (H5/A3) ________________ 119
28.5
Display current consumption in unit (H5/A4) ___________ 121
28.6
Display current consumption COM-loop (H5/A5) _______ 122
28.7
Display statistics for communication (H5/A6) __________ 123
28.8
Activate address setting mode for DU (H5/A7) _________ 125
29
FAULT Acknowledge (H6) _________________ 126
30
Perform ZONE TEST (Test mode) (H7) ______ 127
31
Maintenance (H8) _________________________ 129
31.1
Access code for service / maintenance ________________ 129
31.2
Disconnect loop (H8/S1) ___________________________ 129
31.3
Re-connect loop (H8/S2) ___________________________ 131
31.4
Acknowledge SERVICE signal (H8/S3) _______________ 132
31.5
Clear weekly average (H8/S4) ______________________ 134
31.6
Test of alarm devices (H8/S5) _______________________ 135
31.7
Safe shut down of control unit (H8/S6) _______________ 137
31.8
Activate address in alarm mode (H8/S7) ______________ 139
31.9
Synchronize the control units (H8/S8) ________________ 141
31.10
Change code for service / maintenance (H8/S9) _______ 143
31.11
Change code for PC-communication (H8/S10) _______ 144
32
Interlocking outputs and inputs (H9) _________ 145
32.1
Activated interlocking outputs / inputs (H9/C1) _________ 145
32.2
Activate interlocking output (H9/C2) _________________ 146
32.3
Reset interlocking output (H9/C3) ___________________ 147
32.4
Disable interlocking output (H9/C4) __________________ 148
32.5
Re-enable interlocking output (H9/C5) ________________ 149
33
34
Annual control ___________________________ 151
4
Advertisement
Table of Contents
