Installing A Dvd Drive; Installing The Dvd Drive; Dvd Drive Installation - HP rp3440 Service Manual

Installing a DVD Drive

Install a DVD drive behind the front bezel.
WARNING!
disconnected from the server before removing or replacing a removable media drive.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server. Failure to properly complete
the steps in this procedure will result in erratic server behavior or system failure. For assistance
with this procedure, contact your local HP Authorized Service Provider.
Figure 3-22 DVD Drive Installation

Installing the DVD Drive

To install a DVD drive, follow these steps:
1. Power off the server and disconnect the power and external cables.
2. Remove the front bezel and cover. (See
(page 52).)
3. If a removable media drive has not previously been installed in the server, the drive slot is
covered with a DVD drive filler. Remove the DVD drive filler.
4. Slide the drive into the drive bay until it stops sliding and the retaining clips on both sides
of the drive snap into place
5. Connect the IDE cable on the back of the drive
6. Replace the cover and bezel. (See
(page 52).)
7. Reconnect the power and external cables.
8. Turn on the server.
64 Installing the System
Ensure that the server is powered off and all the power sources have been
Observe all ESD safety precautions before attempting this procedure. Failure to
(Figure
"Removing and Replacing Server Covers and Bezels"
3-22).
(Figure 3-22).
"Removing and Replacing Server Covers and Bezels"