Removing And Replacing The Hard Disk Drive (Scsi) Backplane; Removing The Hard Drive Disk Scsi Backplane; Opening The Fan Power Bridge - HP rp3440 Service Manual

6. Verify the PSI replacement and operation by using the system utilities. (For additional
information, see
Guide.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.

Removing and Replacing the Hard Disk Drive (SCSI) Backplane

Removing the Hard Drive Disk SCSI Backplane

To remove the hard drive disk SCSI backplane, follow these steps:
1. Power off the server and disconnect all the power and external cables.
2. Remove the top cover. (See
3. Lift up on the PCI card cage release lever and the back edge of the PCI card cage and lift the
PCI card cage out of the server. (See
4. Remove fans 2 and 3. (See
5. Lift up on the fan power bridge and disconnect the backplane power cable.
Figure 6-79 Opening the Fan Power Bridge
6. Disconnect the SCSI cables and unscrew the backplane mounting screws.
Appendix B (page 199)
"Removing and Replacing Server Covers and Bezel" (page
"Removing and Replacing the PCI Card Cage" (page
"Removing and Replacing System Fans" (page
Removing and Replacing the Hard Disk Drive (SCSI) Backplane
or the HP Integrity and HP 9000 iLO MP Operations
126).)
167).)
136).)
189