1.
Insert the hard drive backplane onto its four chassis standoffs and slide it to the left as you
face it. This locks the hard drive backplane in place.
2.
Screw in the two backplane mounting screws and connect the two SCSI cables.
3.
Connect the backplane power cable and lower the fan power bridge until it snaps in place.
4.
Replace fans 2 and 3. (See
5.
Replace the PCI card cage. (See
6.
Replace the top cover.
7.
Reconnect all the power and external cables.
8.
Verify the backplane replacement and operation by using the system utilities. (For additional
information, see
Guide.)
•
Use the iLO MP commands to verify operation.
•
Use the BCH commands to verify operation.
192
Removing and Replacing Components
"Removing and Replacing System Fans" (page
"Replacing the PCI Card Cage" (page
Appendix B (page 199)
or the HP Integrity and HP 9000 iLO MP Operations
136).)
168).)