Removing And Replacing A Dual Processor Module; Removing A Dual Processor Module; Disconnecting The Power Pod Cable - HP rp3440 Service Manual

Removing and Replacing a Dual Processor Module

This section provides information about installing dual processor modules. The modules are
located on the system board which is accessible by removing the top cover.
WARNING!
disconnected from the server before removing or replacing a dual processor module.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
behavior or system failure. For assistance with this procedure, contact your local HP Authorized
Service Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions can result in damage to the server.
NOTE: Processor tool kit (HP part number 5069-5441) is required for removal and installation
of a dual processor module.

Removing a Dual Processor Module

To remove a dual processor module, follow these steps:
1. Power off the server and disconnect the power and external cables.
2. Remove the top cover. (See
3. Remove the memory airflow guide and cables. (See
(page 144).)
4. Remove the processor airflow guide and cables. (See
Guide" (page
5. Disconnect the power pod cable from the power connector on the system board
Figure 6-35 Disconnecting the Power Pod Cable
6. Remove and retain the two power pod mounting screws.
Ensure that the server is powered off and all the power sources have been
Failure to properly complete the steps in this procedure will result in erratic system
"Removing and Replacing Server Covers and Bezel" (page
145).)
"Removing the Memory Airflow Guide"
"Removing the Processor Airflow
Removing and Replacing a Dual Processor Module
126).)
155