Removing The Power Pod Mounting Screws; Disconnecting The Power Pod From The Dual Processor Module - HP rp3440 Service Manual

Figure 6-36 Removing the Power Pod Mounting Screws
7. Slide the power pod toward the rear of the system board so that the power pod connector
disconnects from its connector on the dual processor module
Figure 6-37 Disconnecting the Power Pod From the Dual Processor Module
8. Lift the power pod up and out of the chassis
antistatic container.
156 Removing and Replacing Components
(Figure
(Figure 6-38). Place the power pod into an
6-37.