Cisco SPA112 Administration Manual page 146

Installation Options
Mounting the ATA
WARNING
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA100 Series Phone Adapters Administration Guide
Recommended hardware (not included): Two number-six pan-head tapping
screws, 5/8-in. length, with anchors for sheet rock installation.
5/8 in. (15.8 mm)
Insecure mounting might damage the ATA or cause injury. Cisco is not responsible
for damages incurred by insecure wall-mounting.
To mount the unit to the wall:
Determine where you want to mount the unit. Verify that the surface is smooth, flat,
dry, and sturdy.
Drill two pilot holes into the surface 58 mm apart (about 2.28 in.).
Insert a screw into each hole, leaving a gap of 5 mm (0. 1 968 in.) between the
underside of each screw head and the surface of the wall.
Place the unit wall-mount slots over the screws and slide the unit down until the
screws fit snugly into the wall-mount slots.
C
146