Cisco spa112 Setup & User Manual
Hide thumbs
Also See for spa112:
- Administration manual (149 pages) ,
- Quick start manual (13 pages) ,
- User manual (6 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Cisco spa112
Summary of Contents for Cisco spa112
- Page 1 Cisco SPA 112 Setup & User Guide Copyright © 2012 Jaguar Telecom Version 1.8...
-
Page 2: Table Of Contents
2.3 Network Setup ....................4 2.4 Router ......................5 2.5 Check the operation of the SPA112 ................. 6 3 Registration and Account activation ..............6 3.1 Phone Operation ....................6 ... -
Page 3: Introduction
• The ability to apply custom and site specific changes to your configuration. • The document is in two parts, the first section is the setup of a new Cisco as supplied pre-configured for your use 1.1 Shipping List Quantity Description... -
Page 4: Initial Configuration
It is also assumed that the router DHCP server will also provide the IP addresses • of DNS servers to use. It does not matter if the broadband has a static or dynamic IP address. • 2.2 SPA112 Lights Light Description Steady green—On hook. Slow flashing green—Off hook. -
Page 5: Spa112 Back Panel
• Plug in the phone(s) that you are going to use now, using the UK/RJ11 phone • adaptors if necessary. Insert power lead. Power on the Cisco and wait for 60 seconds • Copyright © 2005-2012 Jaguar Telecom Version 1.8... -
Page 6: Router
You should now have a solid green power light, and also a solid green Internet light, If not you must correct the problem with the DHCP before proceeding. 2.5 Router Your router should be set up to perform NAT (Network Address Translation) and act as a DHCP server (or have a standalone DHCP server somewhere on you network). -
Page 7: Check The Operation Of The Spa112
3 Check the operation of the SPA112 3.1 Registration and Account activation Check the Phone 1 and Phone 2 lights on the Cisco, for one subscription on the Cisco you should have one light, and 2 lights for 2 subscriptions. -
Page 8: Internet Light
Slow Blinking ( 0.5s ON, 0.5s OFF ) System Initialisation • Looking for DHCP • long, short, short, off for 2 seconds No Ethernet link detected • Very Fast Blinking , for 30 seconds The unit is being upgraded, NO NOT DISCONNECT OP UNPLUG the unit until •...
Need help?
Do you have a question about the spa112 and is the answer not in the manual?
Questions and answers