Yamaha A4000 Owner's Manual page 250

Installing Optional Equipment
• If an IDE hard drive is also installed, the central connector of the IDE flat cable should be connected to
the hard disk connector (See the illustration, below).
• If no IDE hard disk is installed, secure the central connector of the cable with the cable strap as shown in
the illustration below.
• Damage can result if the loose connector is allowed to come in contact with other internal circuitry. Be sure to
secure the loose connector with the cable strap.
When an IDE hard disk is installed
ZIP Drive
12.
Connect the ZIP drive power cable (short) to one of the power connectors in the A5000/
A4000.
• Connect the hard disk power cable to any of the available power connectors— CN1, CN2, or CN4.
• If no expansion board or hard disk is installed, all three connectors will be available. Any of these connec-
tors can be used.
• If at any time you need to disconnect any of these connectors, do so while pressing the release clip on the
plug. Do not apply excessive force.
The ZIP drive is now fully installed.
There is no need to remove the disk when installing other devices.
13.
Replace the top cover (page 233).
14.
Plug in the power cord.
250
Appendix
• A5000/A4000
When an IDE hard disk is not installed
Internal IDE Hard Disk ZIP Drive