Revert - Yamaha A4000 Owner's Manual

About the COMMANDS

REVERT

[COMMAND/EXIT] Button
Press Knob 5
Restores the selected sample or sample bank to the previously
saved version.
• You use this operation to cancel "errors" that you make when edit-
ing or re-recording a sample. Assume, for example, that you record
a sample, immediately save the results to disk (as you should), and
then start to edit. If you now make a significant error during editing,
you can use the REVERT command to restore the sample to its ini-
tial state. You can then begin editing all over again.
• The Revert command cannot be executed for samples which have
been loaded but not edited, samples which have not been saved, or
imported samples which have not been saved.
• The Revert command cannot be executed if the disk to which the
sample was saved is not connected or mounted.
[Operation]
1.
Select the target sample.
2.
Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the revert
confirmation display will appear. Press Knob 5 (YES) to execute
the revert operation.
Knob 1 Knob 2
Turn
— —
action
Press
EXEC —
action
Knob 1
[ Press] EXEC
Press this knob to call the revert confirmation display.
Press Knob 5 (YES) to actually execute the revert opera-
tion.
Knob 5
[ Turn] Sample
Selects the sample or sample bank to be reverted.
[Range] All samples in memory.
[ Press] EXEC&CONT
Press this knob to call the revert confirmation display.
Press Knob 5 (YES) to actually execute the revert opera-
tion.
230
Chapter 9 COMMAND
Knob 1 to highlight display line 4
Knob 3 Knob 4 Knob 5
— — Sample
— — EXEC&CONT
• A5000/A4000