Yamaha A4000 Owner's Manual page 219

Knob 3
[ Turn] Plus Side Gain
Specifies an amount of amplification (in percent) to be
applied to only the plus side (the section of the waveform
above the center "0" line) of the selected sample's wave-
form. A setting of "100%" normalizes only the plus side of
the waveform. Settings higher than "100%" may produce
clipping.
[Range] 0% — 400%
Knob 5
[ Turn] Minus Side Gain
Specifies an amount of amplification (in percent) to be
applied to only the minus side (the section of the wave-
form below the center "0" line) of the selected sample's
waveform. A setting of "100%" normalizes only the minus
side of the waveform. Settings higher than "100%" may
produce clipping.
[Range] 0% — 400%
[ Press] EXEC&CONT
Press this knob to call the normalize confirmation display.
Press Knob 5 (YES) to actually execute the normalize
operation.
Plus Side Gain set to 100%
(standard normalize)
100%
0%
100%
Plus Side Gain set to 50%
100%
50%
0%
50%
100%
Plus Side Gain set to 200%
100%
50%
0%
50%
100%
Minus Side Gain set to 100%
(standard normalize)
100%
0%
100%
Minus Side Gain set to 50%
100%
50%
0%
50%
100%
Minus Side Gain set to 200%
100%
50%
0%
50%
100%
w
Cursor (when the Process Type is Fade)
Cursor
w
Knob 1 Knob 2
Turn
Cursor Fade Type
action
Press
EXEC —
action
Knob 1
Same function as Cursor
Knob 2
[ Turn] Fade Type
Specifies the type of fade to be created: fade in or fade
out.
[Range] FadeIn, FadeOut
• FadeIn ... Produces a fade-in.
• FadeOut ... Produces a fade-out.
Length
Start address
Length
End address
Knob 3
[ Turn] Curve
This setting selects the curve type for the fade in/out.
Three types are available, as illustrated below.
[Range] -exponent, linear, +exponent
Fade-In Curves
-exponent linear
Level Level
Time
Fade-Out Curves
-exponent linear
Level Level
Time
A5000/A4000 •
About the COMMANDS
Knob 3 Knob 4 Knob 5
Curve Length Length %
— — EXEC&CONT
q
(page 218).
Fade In
Fade Out
+exponent
Level
Time
+exponent
Level
Time
Chapter 9 COMMAND
Time
Time
219