Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
26
Check the spring length.
Guideline
Spring length with preload spacer(s)
482 mm (18.98 in)
If the measured value is larger than the specified value:
-
Reduce the thickness of the preload spacers.
If the measured value is smaller than the specified value:
-
Increase the thickness of the preload spacers.
c
200666-10
6.16
Assembling the seal ring retainer
Info
The steps are identical for both fork legs.
I
Mount and grease seal ring O-
©
Lubricant (T158) (fi9 p. 318)
©
©
Mount and grease O-ring ©.
Lubricant (T158) (ES p. 318)
Position pilot bushing support
©
R00014-10
Assembling the hydrostop unit
6.17
Info
The procedures are the same on both fork legs.
I
Mount and grease O-ring ©-
©
Lubricant (T158) (Ei p. 318)
©
I
Mount washer
©
Mount shim stack
®
with the smaller washers facing downward.
O
Info
Note the setting list.
I
I
R00022-10
Mount the new O-ring on hub ©.
Mount hub ©.
Mount and tighten adapter
©
Guideline
©
©
6 Nm (4.4 Ibf ft)
Hydrostop unit adapter
M6x0.5
R00020-10
Mount washer © and shim set ©.
©
/
Info
Note the setting list.
I
©
Mount sleeve ©.
Turn hydrostop unit and clamp sleeve ©with special tool.
©
Clamping stand (T1202S) (iS p. 332)
<
R00018-10
Advertisement
Table of Contents
