24 CYLINDER HEAD
253
Mount the seat. (Ei p. 83)
Remove the motorcycle from the work stand, (ii p. 12)
24.2
Adjusting the valve clearance
Preparatory work
-
Raise the motorcycle with the work stand. (U p. 12)
-
Remove the seat. (iH p. 82)
-
Take off the side cover. p. 83)
-
Remove the air filter box. (IP p. 78)
-
Check the valve clearance. (®S p. 249)
Intake valves
Push cam lever clip O
U
P and remove.
I*
m
i D02773-10
Push the cam lever aside.
Remove shims
©
and set them down according to the installation position.
Correct the shims based on the results of the valve clearance check.
Insert suitable shims.
Position cam lever.
' II
i)
9&-
r
©
U
D02774-10
Mount cam lever clip O-
m
D02773-10
Remove special tool
©
Engine blocking screw (61229015000) (®P p. 324)
/
Of
Crank the engine several times.
Mount and tighten screw © with the washer.
Guideline
ii
V
Screw plug, crankshaft clamp
M8
15 Nm
(11.1 Ibfft)
D02818-11
Exhaust valves
- Keep turning the crankshaft counterclockwise until autodecompressor
cam
©
is visible next to rocker arm as shown.
0
n
3H-
Info
The autodecompressor cam must be pushed slightly to the side.
I
n
D02775-10