Table of Contents
Advertisement
16 BRAKE SYSTEM
137
Cover painted parts.
Take off screw cap
®
with the washer and membrane.
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
©
Bleed syringe (50329050000) (P p. 320)
'i
Brake fluid DOT 4 (Pi p. 316)
R01425-10
Mount bleeder cover
©
Bleeder cover (00029013004) (P p. 319)
Connect the bleeding device.
re
if
Bleeding device (00029013100) (il p. 319)
/
R01426-10
Open shut-off valve ©.
©
Info
Follow the instructions in the Owner's Manual of the bleeding device.
I
©
V
4
©
Ensure that the filling pressure is set on pressure gauge
o
. Correct the filling
pressure on pressure regulator © if necessary.
Guideline
2... 2.5 bar (29... 36 psi)
Filling pressure
201494-10
Pull off protection cap
©
of the bleeder screw. Connect the bleeder bottle hose.
m
m
Bleeding device (00029013100) (P p. 319)
Open bleeder screw
©
by approx, one half turn.
i
l
Info
Drain until fresh brake fluid emerges in the bleeder bottle hose without
bubbles.
I
u
r
m
Tighten the bleeder screw.
Close shut-off valve ©.
Open the bleeder screw again until brake fluid stops emerging.
D02841 -10
Info
Overfilling of the brake fluid reservoir is prevented.
I
Tighten the bleeder screw. Remove the bleeder bottle hose. Attach the protection
cap.
Disconnect the bleeding device. Remove the bleeder cover.
Add brake fluid up to the MAX marking
O
Brake fluid DOT 4 (iS p. 316)
Mount the screw cap with the washer and membrane.
©
Info
Clean up overflowed or spilled brake fluid immediately with water.
I
rj
D02839-10
__
Advertisement
Table of Contents
