15 WIRING HARNESS, BATTERY
122
Guideline
The charging current, charging voltage, and charging time must not be
exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
-
Connect the battery, (il p. 120)
-
Mount the seat, (il p. 83)
-
Set the clock. (iS p. 139)
Checking the charging voltage
15.6
Condition
The battery must be fully functional and completely charged.
Preparatory work
-
Remove the seat, pp p. 82)
Main work
-
Pull engine electronics control unit O off of the holder and set it to one side.
O
p!
R01415-10
Remove screws
0
Pull retaining bracket
@
of the battery forward and remove it.
Remove positive terminal cover.
Start the motorcycle to check the function. (®S p. 14)
Ti
m
[ ^
IE
©
Ml
— R01416-10
Measure the voltage between the specified points.
Measuring point Plus (+) - Measuring point Ground (-)
V
+
Charging voltage
5,000 rpm
13.5... 15.0 V
» If the displayed value is less than the specified value:
-
Check the plug-in connections from the alternator to the voltage regulator.
-
Check the plug-in connections from the voltage regulator to the wiring
harness.
-
Check the stator winding of the alternator. (K8 p. 244)
» If the displayed value is greater than the specified value:
-
Change the voltage regulator.
Mount the positive terminal cover.
Position retaining bracket
@
Mount and tighten screws
0
Guideline
R01418-10
i
m
[ ^
If
©
10 Nm (7.4 Ibfft)
Remaining screws, chassis
M6
Ml
R01416-10