Working On The Clutch Cover - Husqvarna 701 Enduro 2017 Repair Manual

18 ENGINE
171
Mount and tighten screws © with the washer.
Guideline
Loctite® 243™ Locking screw for bearing M5 6 Nm
(4.4 Ibf ft)
Press in new shaft seal ring
©
of the countershaft and
©
of the shift shaft with
the open side facing inward until it is flush.
Mount and tighten oil nozzle O-
Guideline
4 Nm (3 Ibf ft) Loctite® 243™
Oil jet, piston cooling
M6x0.75
Mount the dowels.
Blow compressed air through all oil channels and check that they are clear.
Measure the spring length of the oil pressure regulator valve.
x
Oil pressure regulator valve - minimum 25.4 mm (1 in)
spring length
» If the measured value does not meet specifications:
- Change the spring.
Check the piston valve for damage and wear.
» If there is damage or wear:
- Replace the piston valve.
Lubricate piston valve © and mount it with pressure spring
0
Mount and
tighten screw plug © with a new seal ring.
Guideline
305602-10
%
WyJj
© 0)
Oil pressure regulator valve plug 20 Nm (14.8 Ibf ft) M12x1.5
m
Position membrane support plate
0
with membrane
0
Mount and tighten the
screws.
Guideline
©
f
A
'
€
mm
Loctite® 243™ Screw, membrane fixation
M3
2 Nm
(1.5 Ibf ft)
311842-10
\A.
Info
The membrane support plate is curved and must point away from the
membrane.
An incorrectly installed membrane support plate results in loss of perfor­
mance and increased oil consumption or leaks.
Do not apply thread locker between the membrane and the membrane
support plate since this would impair their function.
I
18.4.3 Working on the clutch cover
Remove lock ring Q.
Remove shaft seal ring
0
of the crankshaft.
Press in new shaft seal ring as far as possible.
r
m
Info
Provide suitable support for the clutch cover while pressing in.
O
I
V*
Mount lock ring O-
Blow out the oil channel with compressed air and check that it is clear.
I
C
311843-10