Table of Contents
Advertisement
Follow the cautions below. Otherwise physical
CAUTION
injury or property damage may result.
Installation
• Do not install the product on an unstable surface or in
locations exposed to severe vibration.
This may cause the product to topple over or fall
down, resulting in injury.
• Do not install the product in locations directly exposed
to salt water or where corrosive gases or oily smoke are
present.
Contact with such substances may corrode and
degrade the mountings, causing the product to fall
down and cause injury.
Handling Precautions
Installation
• Do not install the product in a location exposed to
direct sunlight or high temperatures.
This may cause malfunctions.
• Do not install the product outdoors.
The product is for indoor use only.
• Do not use or store the product outside the operating
or storage environment.
Failure to do so may result in damage due to the
degradation of image quality or internal components.
• Be sure to connect the ground wire to the GND
terminal.
To prevent electrical shocks caused by electrical
leakage, be sure to connect a ground wire during
installation.
LCD Panel
• Wipe the screen with a soft cloth.
If water droplets get on the screen in an area with
severe temperature difference, or if the screen
becomes dirty, wipe it with a soft dry cloth such as an
eyeglasses cleaning cloth.
Handling
• When moving the product, make sure to disconnect the
power connector and any other connected cables.
Damaging the cables may cause fire or electric
shock.
• Do not place heavy objects on top of the product.
Doing so may lead to injury, deformation of the
product, fire or electric shock.
• Do not block the intake/exhaust ventilation outlet.
Doing so may lead to heat building up inside the
product, burns or fire.
• Do not leave the product in places with high
temperatures or humidity for a long time.
This may cause irregularities in the display quality.
• When the same image is displayed for a long time, it
may remain as an afterimage when the image
changes.
This is a characteristic of the LCD panel and is not a
fault. The afterimage may disappear if you display a
different image for a while.
Handling
• Do not hold and lift the product by the PAN / TILT lever.
Do not use excessive force.
This may cause malfunctions.
• Do not connect a PoE power supply LAN cable to the
RS-422 terminal.
This may cause malfunctions.
Disposal
• Dispose of the product according to local laws and
regulations.
• When disposing of the product, initialize it from
SYSTEM menu > [Initialize] (P. 63) in order to delete
settings information such as network settings and
passwords.
3
Advertisement
Table of Contents
