Canon RC-IP1000 User Manual page 78

System
Settings such as camera name, terminal output signal format and network. Not available when the camera is using a
serial connection (NU Protocol).
Setting item
Camera Name
Frame Frequency (Hz)
Maximum Resolution
12G-SDI
HDMI / 6G-SDI
HDMI / 3G-SDI
3G-SDI
IPv4 Setting Method
Input Volume
IPv4 Address
Subnet Mask
Default Gateway
Apply
Camera Control
Performs operations for the currently selected camera such as recording, tally control and menu operation.
Setting item
Power On
Standby
PGM Tally*
PVW Tally*
Wiper
Washer
REC / STBY
Camera MENU
SET
CANCEL
Assignable Button 1 to
Assignable Button 4
* Not supported during serial connections (NU Protocol).
Setting values/description
Sets the remote camera name (up to 15 alphanumeric characters).
23.98, 29.97 59.94, 25.00, 50.00,
1920x1080, 3840x2160
Selects the output signal format (resolution, frame rate) for the video output terminals.
Displayed setting items differ depending on the camera.
Manual, Auto (DHCP)
Sets the input volume.
Inputs the IPv4 address.
Inputs the subnet mask.
Inputs the default gateway address.
Sets the [System] tab settings to the camera (except for [Camera Name]). This
process may take some time.
Setting values/description
Turns the power on.
Switches to standby.
Turns on/off PGM tally input to the camera.
Turns on/off PVW tally input to the camera.
Activates the camera's wiper (one back-and-forth movement).
Activates the camera's washer and wiper (four back-and-forth movements).
Starts recording on the camera. Press it again to stop recording.
Off, MENU, Custom Picture, FUNC
Selects the camera menu displayed when pressing a USER button assigned to
[Camera Menu].
Used to operate the camera's menus (SET, CANCEL, direction buttons).
Executes functions assigned to the camera's Assignable Buttons 1 to 4.
78