Blomberg KWN 2400XN User Manual page 24

that there is not sufficient ice in the ice
container, you cannot take ice from the
dispenser.
• Do not consume the ice cubes (3-4 litres)
after first running.
• If a power failure or temporary malfunc-
tion arises while the product is running,
ices may melt a little and refreeze. In this
case, ices may stick to each other. In the
event that the power failure or the mal-
function goes on, ices may melt and
cause a water leakage. When such a
problem exists, clean the ice container by
pouring the ices left in the ice container.
WARNING
The water system of the product
should only be connected to cold
water line. It should not be con-
nected to the hot water line.
• Water may not be taken during the first
operation of the product. This is because
there is air in the system. You have to dis-
charge the air in the system. For this pur-
pose, press on the trigger of the dis-
penser for 1-2 minutes until the water
comes from the water dispenser. At the
beginning, the water flow may be irregu-
lar. Water flow will return to normal after
the air in the system is discharged.
• A blurry water may come out when the fil-
ter is used for the first time. The first 10
glasses of water should not be con-
sumed.
• When the product is set up for the first
time, approximately 12 hours should be
passed for the water to cool.
• The water system of the product has
been designed in a way that it can only
work with clean water. Do not use any
beverage except water.
• If you will not use the product for a long
time for the reasons of vacation etc., we
recommend you to cancel the water con-
nection. When the water dispenser is not
used for a long time, the first 1-2 glasses
of water may come out hot.
Drip tray
The water dripping from the water dis-
penser accumulates on the drip tray, there
is not a water outlet. You can take out the
drip tray by pulling it toward yourself or
pressing on its edge. You can clean the wa-
ter in the drip tray in this way.
Ice Machine
Ice machine is on the upper section of the
freezer body.
By grabbing the handle under the front part,
pull the ice storage bin towards yourself to
remove.
To remove the ice storage bin
Grab the handle on the bottom of the bin
and pull it towards yourself.
To reinstall the ice storage bin
Put the bin to its slot and push it back hold-
ing parallel to the ground. Please make
sure that no space will be left between the
bin and the ice maker compartment.
In case you cannot get all the ice cubes
produced
EN / 24
EN
DA
FI