Samsung AE050RXYDEG Installation Manual page 13

Deciding on where to install the outdoor unit
Decide the installation location regarding the following condition and obtain the user's approval .
f The outdoor unit must not be placed on its side or upside down, as the compressor lubrication oil will run into the cooling f
circuit and seriously damage the unit .
f Choose a location that is dry and sunny, but not exposed to direct sunlight or strong winds . f
f Do not block any passageways or thoroughfares . f
f Choose a location where the noise of the Air to Water Heat Pump when running and the discharged air do not disturb f
any neighbours .
f Choose a position that enables the pipes and cables to be easily connected to the other hydrauric system .
f
f Install the outdoor unit on a flat, stable surface that can support its weight and does not generate any unnecessary noise
f
and vibration .
f Position the outdoor unit so that the air flow directly stream towards the open area . f
f Place the outdoor unit where there are no plants and animals because they may cause malfunction of outdoor unit . f
f Maintain sufficient clearance around the outdoor unit, especially from a radio, computer, stereo system, etc . f
Installation Guide at the seashore
Make sure to follow below guides when installing at the seashore .
1 . Do not install the product in a place where it is directly exposed to sea water and sea breeze .
- Make sure to install the product behind a structure (such as building) that can block see breeze .
- Even when it is inevitable to install the product in seashore, make sure that product is not directly exposed to sea
breeze by installing a protection wall .
2 . Consider that the salinity particles clinging to the external panels should be sufficiently washed out .
3 . Because the residual water at the bottom of the outdoor unit significantly promotes corrosion,
make sure that the slope does not disturb drainage .
- Keep the floor level so that rain does not accumulate .
- Be careful not to block the drain hole due to foreign substance
4 . When product is installed in seashore, periodically clean it with water to remove attached salinity .
5 . Make sure to install the product in a place that provides smooth water drainage . Especially, ensure that the base part has
good drainage .
6 . If the product is damaged during the installation or maintenance, make sure to repair it .
7 . Check the condition of the product periodically .
- Check the installation site every 3 months and perform anti-corrosion treatment such as R-Pro supplied by SAMSUNG
(Code : MOK-220SA) or commercial water repellent grease and wax, etc . , based on the product condition .
- When the product is to be shut down for a long period of time, such as off-peak hours, take appropriate measures like
covering the product .
8 . If the product installed within 500m of seashore, special anti-corrosion treatment is required .
❋ ❋ Please contact your local SAMSUNG representative for further details .
Outdoor
Sea breeze
Sea
Outdoor
unit
unit
ENGLISH-13