Table of Contents
Advertisement
3. Fit the two plastic wall spacers
supplied with the appliance rotating
1/4 turn to the condenser at the back
of the refrigerator (see diagram).
4. The appliance should be located
on a smooth surface. The two front
feet can be adjusted as required.
To ensure that, your appliance is
standing upright adjust the two
front feet by turning clockwise or
anti-clockwise, until the product is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
5. Refer to "Cleaning and Care" section
to prepare your appliance for use.
6. This appliance has been designed
to operate in ambient temperatures
between +10 and +32 degrees C (50
and 90 degrees F). There fore if the
appliance is installed in an unheated
/ cold room (E.g.: Conservatory /
annex / shed / garage etc.) then the
appliance may not operate and as a
result the storage time of food may
be reduced.
7. A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
8. Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
9. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
10
EN
Advertisement
Table of Contents
