Adjusting The Clip Rate; During Operation; During Operation Safety - Toro Greensmaster eFlex 1021 Operator's Manual

Adjusting the Clip Rate

1. Determine the appropriate clip rate per the following table:
Clip Rate
Reel Speed
Low
Low
High
High
2. Adjust the reel speed control to the H
3. Set the reel-drive pulley on the cutting unit to the H
to your cutting unit Operator's Manual.

During Operation

During Operation Safety

General Safety
• The owner/operator can prevent and is responsible for accidents that may cause
personal injury or property damage.
• Wear appropriate clothing, including eye protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long hair and do not wear loose clothing or
loose jewelry.
• Do not operate the machine while ill, tired, or under the influence of alcohol or drugs.
• Use your full attention while operating the machine. Do not engage in any activity that
causes distractions; otherwise, injury or property damage may occur.
• Before you turn on the machine, ensure that all drives are in neutral, the parking brake is
engaged, and you are in the operating position.
• Keep bystanders and children out of the operating area. If co-workers must be present,
use caution and ensure that the grass basket is installed on the machine.
• Operate the machine only in good visibility to avoid holes or hidden hazards.
• Do not operate the machine when there is the risk of lightning.
• Use care when mowing on wet grass. Poor footing could cause a slip-and-fall accident.
• Keep your hands and feet away from the cutting unit.
Operation: Before Operation
Pulley
Position
8-blade
Low 7.3 mm (0.286 inch)
High 6.1 mm (0.241 inch)
Low 5.9 mm (0.233 inch)
High 5.0 mm (0.196 inch)
Page 5–2
Cutting Unit
11-blade
5.3 mm (0.208 inch)
4.4 mm (0.175 inch)
4.3 mm (0.169 inch)
3.6 mm (0.142 inch)
or L setting as needed.
IGH OW
or L
IGH
14-blade
4.2 mm (0.164
inch)
3.5 mm (0.137
inch)
3.4 mm (0.133
inch)
2.8 mm (0.112
inch)
position as needed; refer
OW
3460-892 A