OPTIONAL ACCESSORIES
Vise pressure regulator
Pressure
gauge
Pressure adjusting valve
Hydraulic top clamp
Chip conveyor
2M roller table
4-10
This adjustment valve is used to control vise pressure.
Adjust vise pressure based on the material of your workpiece.
When cutting pipes or soft materials, reduce vise pressure to
prevent exerted pressure from damaging the workpiece shape or
exterior.
Do not adjust vise pressure at any time during cutting.
Vise pressure should never be lower than 8 kg/cm
The top clamp device is installed on the vise. Before executing bundle
cutting, open the adjustment valve so the top clamp can move in sync
with the vise.
Note the allowable clamping width and height. (Refer to Specifications
of section 2 – General Information.)
Chip conveyor is a spiral device to bring chips out during cutting.
As a regular maintenance, remove the chip conveyor and clean all chip
deposits inside.
The optional 2M roller table supports the work material and
ensures the material is fed in smoothly.
Refer to Section 9 for further information on adjusting the
roller table.
2
.