Sharp SW-165HT Instruction Manual page 52

Proper
Step 2 – Align the top clamp cylinders with the center of the workpiece and tighten the lock nuts.
Step 3 – Open the adjustment valve (pointed by the arrow), which is used to adjust the top clamp
speed during clamping/unclamping.
Step 4 – Install the bundle-cutting fence to the work tray. The fence is designed to prevent cut pieces
from scattering across the work tray. Adjust the width of the fence to be slightly larger
than the width of the bundle.
Step 5 – For subsequent cutting procedures, refer to the instructions under manual operation and
automatic operation.
TERMINATING A CUTTING OPERATION

To terminate a cutting operation, press either the saw bow up button or the emergency stop
button.

The saw blade will stop running when the saw bow up button is pressed.

Both the saw blade and hydraulic pump motors will stop running when the emergency stop
button is pressed.
4-20
Proper and improper stacking of workpieces
Improper