Control Buttons - Sharp SW-165HT Instruction Manual

Control Buttons

1. Power indicator lamp
When the lamp is on, it indicates the power to the machine is turned on.
2. Hydraulic start/stop buttons with built-in lamp (CE model)
Hydraulic start button with built-in lamp (non-CE model)
CE model
When the green button is pressed, the built-in-lamp will come on and the hydraulic motor starts to
operate. When the red button is pressed, the hydraulic motor turns off immediately.
Non-CE model
When this button is pressed, the built-in-lamp will come on and the hydraulic motor starts to operate.
Press emergency stop button to stop the hydraulic motor.
When the hydraulic motor is ON, the chip conveyor will run at the same time, please keep your
hands away from the chip conveyor.
3. Emergency stop button
Press this button to stop the machine in an emergency. When the button is pressed, it brings the
machine to a full stop. The button locks when pressed. In order to unlock it, please turn the button
clockwise.
4. Last cut function on/off switch
When this mode
triggers the lower limit switch, but the hydraulic system will remain ON.
When this mode
job and triggers the lower limit switch, and the hydraulic system will shut down (in 10 seconds).
5. Saw blade start/stop buttons with built-in lamp (CE model)
Saw blade start button with built-in lamp (non-CE model)
CE model
When the green button is pressed, the built-in-lamp will come on and the blade motor starts to
operate. When the red button is pressed, the blade motor stops.
Non-CE model
When this button is pressed, the built-in-lamp will come on and the blade motor starts to operate.
Press saw bow up button to stop the blade motor.
is selected, the blade will automatically stop as it completes the current job and
is selected, the blade will automatically stop as it completes the current
4-5