Table of Contents
Advertisement
the beacon cable through the bottom and out
through the top.
3.
Connect the beacon cable, ensuring that the
red connector is fitted to the central positive
terminal of the beacon stand fitting, and the
brown connector to the outer terminal. Screw
the fitting back into the beacon stand.
Note:
Rotate the cable as you screw in the
connector. This prevents the cable from being
twisted.
4.
Loosen the wing nut on the beacon
Figure 17
1. Wing nut
5.
Assemble the beacon onto the top of the beacon
stand
(Figure
18).
Figure 18
6.
Tighten the wing nut on the clamp
(Figure
17).
1. Bolt
2. Washer
g344043
Installing the Switch
1.
2.
3.
g344107
(Figure
19).
6
Figure 19
Locate, remove, and discard the blanking plug
on the main control panel.
Note:
The blanking plug is located on the end
or side of the main control panel depending on
the machine model.
Pull out the switch connector labeled B
and plug in the switch.
Press the switch into the cutout until it clicks into
place
(Figure 20
and
Figure
g344104
3. Lock washer
4. Wing nut
EACON
21).
Advertisement
Table of Contents
