Table of Contents
Advertisement
Removing the Bulkhead Panel
1.
If a road light is installed on the machine,
disconnect the 2 pin connector from the number
plate.
2.
Remove the 4 bolts (6 x 25 mm), 4 lock washers
(6 mm), and 4 flat washers (6 mm) that secure
the bulkhead panel to the chassis of the machine
(Figure
7).
1. Bulkhead panel
2. Flat washer
3.
Move the panel up and forward, and remove it
from the machine
Installing the Kit
Installing the Brackets
For Machines Without Cabs Only
Note:
You can install the beacon light on either side
of the ROPS frame. If you drive on the left side of
the road, install the beacon on the right side if the
machine. If you drive on the right side of the road,
install the beacon on the left side of the machine.
1.
Ensure that the ROPS pivot bolts and pins are
in place and tight.
2.
On the same side of the ROPS on which you
plan to install the kit, remove the nut and bolt
from the ROPS and discard them; refer to
8.
Figure 7
3. Lock washer
4. Bolt
(Figure
7).
1. Bolt (discard)
2. Lanyard washer
3.
Align the hole in the ROPS bracket with the hole
in the ROPS and install the new bolt
g037067
1. Large bolt
2. ROPS bracket
4.
Install the new large locknut and the existing
lanyard washer, and tighten the locknut.
Note:
make the ROPS difficult to fold.
5.
Align the small holes in the beacon bracket with
Figure
the upper holes in the ROPS bracket
10), and secure the brackets with 2 bolts (M6 x
20 mm) and 2 locknuts (M6).
3
Figure 8
3. Locknut (discard)
Figure 9
3. Lanyard washer
4. Large locknut
Do not overtighten them, as this will
g344020
(Figure
9).
g344021
(Figure
Advertisement
Table of Contents
