Installing The Weight; Loose Parts; Procedure; Bolt (3/8 X 1-1/4 Inches) - Toro 79393 Operator's Manual

1

Installing the Weight

Parts needed for this procedure:
4

Bolt (3/8 x 1-1/4 inches)

4

Locknut (3/8 inch)

1 Weight mounting bracket, left
1 Weight mounting bracket, right
4

Washers

1

Weight bracket

2

Bolt (3/8 x 1 inch)

1

Flat weight

1

Suitcase weight

1 Keyed cross bar

Procedure

Note: This procedure is only for models with control levers.
Steering wheel models do not need weights installed.
CAUTION
The bagger changes the weight distribution of the
machine. Operating the machine without the front
weights may cause an unstable condition which
could result in a loss of control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Locate the front bolts on the underside of the frame
(Figure 3 and Figure
2. Remove the 2 bolts (3/8 x 1 inch) and 2 locknuts (3/8
inch). Retain the locknuts.
4).
1
1. Front-right caster (castor
fork and wheel not shown
for clarity)
2. Front hole, right side
1
1. Locknut (3/8 inch)
2. Front hole, left side
3. Locate the left and right weight-mounting brackets in

loose parts.

4. Install the left bracket to the under side of the frame
using 2 bolts (3/8 x 1-1/4 inches), 2 washers and 2
locknuts (3/8 inch)
Note: Use 1 locknut from the loose parts and the
other from 1 of the locknuts that you previously
removed.
5
2
3
4
Figure 3
3. Bolt (3/8 x 1 inch)
4. Locknut (3/8 inch)
3
2
G014877
4
Figure 4
3. Front left caster (castor
fork and wheel not shown
for clarity)
4. Bolt (3/8 x 1 inch)
(Figure 5).
G014875