Table of Contents
Advertisement
1. Beacon bracket
2. Bolt (M6 x 20 mm)
Installing the Beacon on a Machine
without a Cab
1.
Install the beacon stand to the beacon bracket
(Figure
11).
Figure 10
3. Locknut (M6)
1. Beacon stand
2. Seal
3. Nut
2.
To fit the beacon cable, start by removing the
fitting in the top of the beacon stand and feed
the beacon cable through the bottom and out
through the top.
3.
Connect the beacon cable, ensuring that the
positive (yellow) wire is fitted to the central
positive terminal of the beacon stand fitting, and
g345641
the black wire to the outer terminal. Screw the
fitting back into the beacon stand.
Note:
Rotate the cable as you screw in the
connector. This prevents the cable from being
twisted.
4.
Loosen the wing nut on the beacon
1. Wing nut
5.
Assemble the beacon onto the top of the beacon
stand
(Figure
4
Figure 11
4. Ferrite
5. Beacon cable
(Figure
Figure 12
13).
g344042
12).
g344043
Advertisement
Table of Contents
