Preparing The Machine; Installing The Ce Kit; Installing The Cutting Unit To The Traction Unit - Toro Groundsmaster 3200 Series Operator's Manual

1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
2

Installing the CE Kit

If Required (CE-Compliant
Countries Only)
No Parts Required
Procedure
If you use this machine in a country that complies
to CE standards, install the CE Kit; refer to the kit
Installation Instructions.
3
Installing the Cutting Unit
to the Traction Unit
Parts needed for this procedure:
2 Hex-head bolt
2 Washer
2 Height-of-cut pin
Procedure
1. Park the machine on a level surface, move
the lift arms to the lowest position, engage the
parking brake, shut off the engine, and remove
the key.
2. Position the cutting unit in front of the traction
unit.
3. Slide the PTO-shaft yoke onto the gearbox shaft
and secure the shafts together with 2 bolts and
nuts in opposite directions
1. Gearbox
2. PTO shaft
4. Tighten the bolts and nuts
5. Push a lift arm down until the holes in the lift arm
line up with the holes in the castor arms, then
insert a washer and bolt through both arms.
6. Align the lift-arm holes with the castor-arm holes.
7. Use 2 hex-head bolts and 2 washers to secure
the castor arms to the lift arms
9
(Figure 3).
Figure 3
3. Bolts and nuts
(Figure 3).
(Figure 4).
g299646