Table of Contents
Advertisement
each sweep, until you have removed the front
portion of the stump to ground level (A through
D in
Figure
11).
7.
Raise the cutting wheel, release the parking
brake, and move the machine forward a few
centimeters (inches). Engage the parking brake.
8.
Repeat steps
5
and
removed the stump (E through H in
9.
Move throttle to the D
the handle down enough to raise the cutting
wheel off the ground. Wait for the cutting wheel
to stop rotating then release the parking brake
and pull the machine away from the stump.
Note:
Do not let the front of the machine touch
the ground until the cutting wheel has stopped
turning.
10.
Shut off the engine; refer to
Engine (page
10).
Lifting the Machine
Use the handles shown in
1. Lift handle (4)
7
until you have completely
Figure
position, push
ISENGAGE
Shutting Off the
Figure 12
as lift points.
Figure 12
11).
g205090
12
Advertisement
Table of Contents
