Maintenance; Recommended Maintenance Schedule(S); Lubrication; Greasing The Machine - Toro 22615 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Important: You can tip the machine backward or on its side to clean or service it, but no longer than 2 minutes. If
you hold the machine this position for too long, fuel can drain into the crankcase and damage the engine. Should
this happen, perform an extra oil change on the engine. Then turn the engine over a few revolutions with the starter
handle before starting the engine again.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 25 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Important: Refer to your engine owner's manual for additional maintenance procedures.

Lubrication

Greasing the Machine

Service Interval: Before each use or daily
Grease Type: General-purpose grease.
1. Clean the grease fittings with a rag.
2. Connect a grease gun to each fitting.
3. Lubricate 2 fittings, 1 on each cutting wheel bearing.
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Important: Pump grease in slowly and carefully
to prevent damage to the bearing seals.
Maintenance Procedure
• Change the oil.
• Check the engine-oil level.
• Grease the machine.
• Check the air filter.
• Check the drive belt tension.
• Check the condition of the teeth; rotate or replace any that are worn or damaged
and torque the nuts for all teeth.
• Remove debris from the machine.
• Service the air filter.
• Change the oil (more frequently when conditions are extremely dusty or sandy).
• Clean the sediment cup.
• Check the spark plugs.
• Replace the drive belt.
• Replace the air filter.
• Change the oil.
• Clean the sediment cup.
13
Figure 10