Table of Contents
Advertisement
Grinding a Stump
DANGER
This machine is capable of amputating hands
and feet.
• Always wear substantial, slip-resistant
footwear.
• Stay in the operating position while the
machine is running, and keep away from
moving parts.
• Keep all bystanders a safe distance away
from the machine.
• Stop the machine immediately if any
people or animals enter the work area.
WARNING
Grinding a stump throws wood chips, soil,
and other debris into the air, which could
injure you or bystanders.
• Always wear eye protection and long pants
when using the grinder.
• Keep all bystanders a safe distance away
from the grinder.
WARNING
The grinder is very loud when cutting a stump
and can damage your ears.
Always wear hearing protection when using
the grinder.
1.
Set throttle to the D
engine, and allow the machine to warm up for
2 minutes.
2.
Push the handle down enough to raise the
cutting wheel off the ground
position, start the
ISENGAGE
(Figure
10).
1. Pivot point
3.
Move the machine to the front of the stump and
engage the parking brake.
4.
Move throttle up to the E
cutting wheel will begin rotating.
5.
Swing the cutting wheel to one side
then lower it approximately 1 to 2.5 cm (1/2 to 1
inch) into the front-top corner of the stump.
6.
Using a sweeping motion, swing the cutting
wheel back and forth, lowering the cutting wheel
approximately 1 to 2.5 cm (1/2 to 1 inch) before
11
Figure 10
2. Pivot point when the
parking brake is engaged
position. The
NGAGE
(Figure
Figure 11
g024063
10),
g024062
Advertisement
Table of Contents
