Table of Contents
Advertisement
1. Choke
2. Fuel valve
Choke Lever
Use the choke lever
(Figure
Before pulling the recoil-start handle, move the choke
lever to the C
position. Once the engine is
LOSED
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
Recoil-Start Handle
To start the engine, pull the recoil-start handle
6) quickly to turn the engine over. Refer to
Engine (page 10)
for the correct starting procedure.
Specifications
Note:
Specifications and design are subject to
change without notice.
Cutting Depth
Length
Width
Height
Weight
Figure 6
3. Recoil-start handle
6) to start a cold engine.
position.
PEN
Starting the
30 cm (12 inches)
193 cm (76 inches)
75 cm (29.5 inches)
107 cm (42 inches)
109 kg (240 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Important:
oil level, and remove debris from the machine.
Also, ensure that the area is clear of people and
debris. You should also know and have marked
the locations of all utility lines.
Before you Start
g015174
•
Dig away the earth and remove any stones near
the tree stump that may interfere with your work.
Check that the ground is free of foreign objects,
such as electrical cables, barbed wire, etc.
•
Cut or trim the stump using a power saw.
•
Review all the safety decals on the machine.
•
Ensure that you are familiar with safety regulations
and shutdown procedures described in this
manual.
•
Ensure that all guards are in place and in good
condition.
•
Ensure that the blades and cutters are in place
and in good condition.
•
Ensure that the work area, cutter, and stump in
particular are free from metallic objects such as
(Figure
wire, nails, etc. that could be thrown out and injure
persons in the vicinity and damage the equipment.
Think Safety First
Carefully read all safety instructions and symbols in
the safety section. Knowing this information could
help you or bystanders avoid injury.
CAUTION
This machine produces sound levels that can
cause hearing loss through extended periods
of exposure.
Wear hearing protection when operating this
machine.
1. Wear hearing protection.
8
Before operating, check the fuel and
Figure 7
g229846
Advertisement
Table of Contents
