Table of Contents
Advertisement
6
Adjusting the Rear Grass
Shield
No Parts Required
Procedure
Note: When operating in turf conditions where much debris
or unusually heavy thatch is encountered, open the rear
discharge shield to help allow the debris to discharge from
the reel.
1. Loosen the bolts on the pivot of the grass shield
(Figure
10).
Figure 10
1. Pivot bolt
2. Rotate the grass shield to the desired setting, and
tighten the bolts
(Figure
CAUTION
Thrown debris could cause personal injury.
Do not open the rear shield so that it is higher than
level to ground.
2. Rear grass shield
10).
7
Adjusting the Roller Scrapers
No Parts Required
Procedure
1. Loosen the flange nuts that secure the roller scrapers
(Figure
11).
1. Flange nuts
2. Front roller scraper
2. Move the scraper rods in or out to attain 0.0 to 0.75
mm (0.0 to 0.03 inch) clearance between the scraper
and the roller.
3. Ensure that the scraper rod is parallel to the roller and
to the level surface.
4. Tighten the flange nuts to lock the adjustment.
8
g195550
Adjusting the Transport
Rollers
No Parts Required
Procedure
Before the verticutters are lowered to the shop floor or
removed from the traction unit, lower the transport rollers
(Figure
11) to protect the blades from hard surface contact.
1. Remove the cotter pin that secures the transport roller
bracket to the side plate pin.
2. Position the transport roller as follows:
•
Lower the roller bracket before the verticutter is
lowered to the shop floor.
•
Raise the roller bracket after the verticutter is raised
to the operating position.
8
Figure 11
3. Rear roller scraper
g195551
Advertisement
Table of Contents
