Installing The Verticutter Blades; Servicing The Roller - Toro 03731 Operator's Manual

Installing the Verticutter
Blades
1. Assemble a reel blade
2. Assemble a large spacer.
3. Do not invert the reel blades when reassembling them
onto the reel shaft.
Note: If the blades are inverted, the blades that are
in use (rounded) will be mixed with the sharp ends
of the blades which were not in use. This will cause
unsatisfactory performance in the verticutter reel unit.
Pay close attention when disassembling the verticutter
blades from the reel.
4. Install the next blade clockwise so that the index
reference hole (Figure
blade hole by one flat of the shaft.
1. Index reference hole
5. Continue to install spacers and blades in this manner
until the full complement of blades has been installed.
Note: When properly assembled, the blades will be
staggered in such a manner as to appear like a helix.
6. Install the small spacer to the shaft.
7. Apply Blue Loctite 242 to the nut. Install the nut onto
the shaft, (with the machined side of the nut toward
the spacer) and tighten it to 108.5 to 135 N∙m (80 to
100 ft-lb).

Servicing the Roller

A Roller Rebuild Kit, Part 114-5430 and a Roller Rebuild
Tool Kit, Part 115-0803 (Figure
the roller. The Roller Rebuild Kit includes all the bearings,
bearing nuts, inner seals, and outer seals to rebuild a roller.
The Roller Rebuild Tool Kit includes all the tools and the
installation instructions required to rebuild a roller with the
roller rebuild kit. Refer to your parts catalog or contact your
distributor for assistance.
(Figure 18).
18) is not aligned with the first
Figure 18
19) are available for servicing
g010890
13