Adjusting The Cutting Height; Starting The Engine - Toro HoverPro 450 Operator's Manual

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Wear gloves while handling the flexiblade or
cutterbar.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired.
1. Turn the fuel switch to the off position.
2. Disconnect the wire from the spark plug.
3. Tilt the machine on its left side.
4. Wearing protective gloves, remove the
flexiblade/cutterbar.
5. Remove the retaining bolt.
6. Reposition the spacers to the desired height, then
reinstall the flexiblade/cutterbar (Figure 13, Figure 12).
1
2
3
4
1. Spacers
2. Blade retainer
3. Bolt
g017331
Figure 12
4. Flexiblade
5. Blade retainer
1. Cutterbar
2. Spacers
3. Blade retainer
Note: The large spacer must be positioned directly
below the impeller at all times.

Starting the Engine

1. Place the throttle control to the choke position, ensure
that the fuel switch is in the 'On' position.
5
2. Hold the engine stop handle against the handle.
11
Figure 13
4. Bolt
5. Large spacer
OFF
ON
g017346
Figure 14