Adjusting The Rear-Roller Height - Toro Greensmaster 3150 Series Operator's Manual

Figure 14
Models 03639 and 03641
1. 1.3 mm (0.050 inch)
2. Spin grind the reel to achieve <0.025 mm (0.001
inch) reel run-out.
Note:
This causes the land width to grow
slightly.
Note:
To extend the longevity of the sharpness of the
edge of the reel and the bedknife—after grinding the
reel and/or the bedknife—check the reel to bedknife
contact again after cutting 2 fairways, as any burrs
will be removed, which may create improper reel to
bedknife clearance and thus accelerate wear.
Adjusting the Rear-Roller
Height
Depending on your desired height-of-cut range, you
need to adjust the rear-roller brackets
Figure 16) to the low or high position:
•
Position the spacer above the sideplate-mounting
flange (factory setting) when the height-of-cut
settings range from 1.5 mm to 6 mm (1/16 inch to
1/4 inch) as shown in
2. 30 degrees
(Figure 15
Figure 15.
1. Spacer
2. Sideplate-mounting flange
g028838
•
Position the spacer below the sideplate-mounting
flange when the height-of-cut settings range from
3 mm to 25 mm (1/8 inch to 1 inch) as shown in
Figure 16.
1. Sideplate-mounting flange
2. Spacer
1. Raise the rear of the cutting unit and place a
block under the bedknife.
2. Remove the 2 nuts securing each roller bracket
or
and spacer to each sideplate mounting flange.
3. Lower the roller and bolts from the sideplate
mounting flanges and spacers.
4. Place the spacers onto the bolts above or below
the roller brackets, as required
Figure 16).
5. Secure the roller bracket and spacers to the
underside of the mounting flanges with the nuts
previously removed.
Note:
The position of the rear roller to the reel
is controlled by the machining tolerances of the
assembled components and paralleling is not
required.
11
Figure 15
3. Roller bracket
Figure 16
3. Roller bracket
(Figure 15
g014404
g014405
or