Toro Workman GTX Installation Instructions Manual page 5

3. Install 4 rubber grommets onto the rear-seat handle (A of
4. Install 2 countersunk screws (1/4 inch) and 2 locknuts (1/4 inch) onto the rear-seat handle (B of
5. Feed the hold-down strap through the bottom of the footrest (C of
6. Install the rear-seat handle onto the footrest (D of
7. Secure the rear-seat handle to the footrest by pulling the hold-down strap up and around the countersunk
screw (E of Figure
8. Install the side rails to the flatbed assembly with 8 carriage bolts (3/8 x 3 inches) and 8 hex nuts (3/8
inch) as shown in
1. Carriage bolt (3/8 x 3 inches)
8).
Figure 9.
Figure 8).
Figure
Figure 8).
Figure 8
Figure 9
2. Hex nut (3/8 inch)
5
8).
Figure 8).
g243744
g258079