Toro Workman GTX Installation Instructions Manual page 3

Removing the Plastic Cargo
Bed
1. Using an overhead hoist, raise the plastic cargo
bed.
2. Remove the 3 flange-head screws (5/16 x 3/4
inch) and U-bracket from the prop rod
Note:
Retain the hardware to install the plastic
cargo bed in the future.
1. Prop rod
2. U-bracket
3. Slide the prop rod forward out of the detent slot
and remove the prop rod
1. Detent slot
(Figure
Figure 2
3. Flange-head screw (5/16
x 3/4 inch)
(Figure 3).
Figure 3
2. Prop rod
4. Using an overhead hoist, lower the cargo bed.
5. Remove the 2 pivot bolts (1/2 x 4-1/2 inches)
and 2 locknuts (1/2 inch) from the pivot bracket
located at the rear of the machine
Note:
Retain the hardware for installation
of the flatbed assembly in
Rear-Facing Seat (page
2).
1. Pivot bolt (1/2 x 4-1/2
inches)
2. Pivot bracket
6. Release the cargo-bed lever, then raise and
remove the cargo bed using an overhead hoist.
7. Remove the 2 bed latches from the frame of the
machine by removing the 4 flange-head screws
(3/8 x 2-1/2 inches) and 4 nuts (3/8 inch) as
g244196
shown in
Note:
Retain 2 flange-head screws (3/8 x 2-1/2
inches) and 2 nuts (3/8 inch) for installation
of the flatbed assembly in step
the Rear-Facing Seat (page
remaining hardware to install the plastic cargo
bed in the future.
g037393
1. Flange-head screw (3/8 x
2-1/2 inches)
2. Bed latch
3
1 in Installing the
4).
Figure 4
3. Locknut (1/2 inch)
Figure 5.
1
4). Retain the
Figure 5
3. Nut (3/8 inch)
(Figure 4).
g037303
in Installing
g243577