Hex Nut (3/8 Inch); Button-Head Screw (3/8 X 1 Inch) - Toro Workman GTX Installation Instructions Manual
Fold-down rear facing seat
Hide thumbs
Also See for Workman GTX:
- Service manual (187 pages) ,
- Operator's manual (60 pages) ,
- Operator's manual (52 pages)
Advertisement
Installing the Rear-Facing Seat
1.
Install the flatbed onto the frame of the machine using the 2 pivot bolts (1/2 x 4-1/2 inches), 2 locknuts (1/2
inch), 2 flange-head screws (3/8 x 2-1/2 inches), and 2 nuts (3/8 inch) previously removed in steps
7
of
Removing the Plastic Cargo Bed (page
1. Nut (3/8 inch)
2. Flange-head screw (3/8 x 2-1/2 inches)
2.
Attach the footrest onto the flatbed using 2 carriage bolts (3/8 x 3 inches), 7 button-head screws (3/8 x 1
inch), and 9 hex nuts (3/8 inch) as shown in
1. Carriage bolts (3/8 x 3 inches)
2. Button-head screw (3/8 x 1 inch)
3). Refer to
Figure
6.
Figure 6
3. Locknut (1/2 inch)
4. Pivot bolt (1/2 x 4-1/2 inches)
Figure
7.
Figure 7
3. Hex nut (3/8 inch)
4
5
and
g243601
g243647
Advertisement
