Panasonic VB-44210G User Manual page 340

Appendix B. CPC-AII/B 8.0 Feature Update
Page B-14
Incoming Calls
• You cannot program both devices to ring simultaneously.
• The "*71" code will not work if the other device is in use.
• The "*71" code will not work if FF3 (ExtPort)# 51# is set to "0".
• If set to "Analog port RING", the large-display phone will work like an
SLT/OPX (no page announcements, no voice calls from other
extensions, etc.).
• If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone
will remain in CF/DND even if the ringing device is changed via the
*71 code.
• The incoming ring pattern for the analog device is the same as for the
digital key telephone (determined by the Extension Ring Pattern in FF3
(ExtPort)# 39# (0-9)#). If this address is set to "0" (determined by CO),
the analog device will automatically default to "1 second ON, 3 seconds
OFF."
Ring Patterns Not Applicable to Analog Device. The following ring
pattern addresses will not affect the analog device:
Analog Transfer Ring Pattern FF1 2# 1# 31# (0-6)#
SLT DISA Ring Pattern
Inbound Ring Pattern
Flash Interaction. Any disconnect signal sent to the analog port must be
greater than the SLT Flash Control; otherwise the disconnect signal will be
interpreted as a flash and the call will be placed on hold.
Programming Addresses That Affect the Analog Device. The following
addresses will control the analog device, but will not affect the digital key
telephone:
AEC Disconnect Duration
SLT Flash Control
SLT Onhook Flash Timer
AEC Disconnect
or 1)#
Analog Port on Large-Display Phone
or 1)#
Data Security on Analog Port
or 1)#
DBS Manual - Revised April 2000
Section 700-Operation
FF1 2# 1# 34# (0 or 1)#
FF2 (Trunk)# 17# (0-9)#
FF1 2# 1# 35# (0-15)#
FF1 2# 1# 11# (0 or 1)#
FF1 3# 14# (0-6)#
FF3 (ExtPort)# 46# (0
FF3 (ExtPort)# 51# (0
FF3 (ExtPort)# 52# (0
DBS-2.3/9.2-700