Panasonic VB-44210G User Manual page 164

Chapter 4. Key Telephone Features
Note: FF keys assigned as CO lines must be cleared using system
programming before new FF assignments can be made.
Operation
To assign pre-programmed codes to an FF key:
1. Press the ON/OFF key:
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Enter the code to be programmed (see Table 4-6).
5. Press the HOLD key.
6. Repeat steps 2-5 to program additional keys.
7. Press the ON/OFF key.
To assign digits to an FF key:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Enter up to six digits.
5. Press the HOLD key.
4-48
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
"F" appears on the display.
"Enter Code" appears on the display.
The programmed code appears on the display.
"Code Stored" appears on the display.
The ON/OFF LED goes off.
"Enter Code" appears on the display.
DBS Manual - Revised April 2000
Section 700 - Operation
DBS-2.3/9.2-700