Panasonic VB-44210G User Manual page 169

Section 700 - Operation
Feature
Voice Mail Transfer Key
(CPC-AII and CPC-B Version
6.0 or higher)
One-Touch VM Access
(CPC-AII and CPC-B Version
5.0 or higher)
• If a new code is programmed into a key, the previously programmed code
• To erase a code programmed into a key, press the HOLD key when the
• The system can be programmed so that Pooled Trunk Access calls
• Night Service, DND, and BGM can be activated through FF keys without
• When you are making a call using the Speed Dialing feature, the FLASH
• When an extension is assigned to an FF key, the FF key changes colors to
DBS-2.3/9.2-700
Code to be entered
CONF, AUTO AUTO, NNN XXX or AUTO Speed Dial
Note: If a password is used, it can be from 1 to 3 digits. If
the password is over 3 digits, it must be assigned to a per-
sonal or system speed dial number . Include an ending # sign
in the speed dial number if you are accessing a DBS voice
mail system.
Note: If a password is used, it can be from 1 to 3 digits. If
the password is over 3 digits, it must be assigned to a per-
sonal or system speed dial number . Include an ending # sign
in the speed dial number if you are accessing a DBS voice
mail system.
is erased.
display reads "Enter Code." "Code Cleared" then appears on the display.
automatically use LCR when 9 is selected.
lifting the handset.
key stored in Speed Dialing becomes the PBX flash feature.
indicate the status of the extension as follows:
- RED (solid) -- extension busy
- RED (flashing) -- incoming call or receiving call waiting (DSS/
72 and EM/24 keys stay solid red instead of flashing red)
- GREEN -- either DND, call forwarding, or absence message
set.
DBS Manual - Revised April 2000
Chapter 4. Key Telephone Features
Voice mail
pilot number
AUTO NNN XXX or AUTO Speed Dial#
Voice mail
pilot number
Password (optional)
Password (optional)
4-53